The installation of a dishwasher isn’t complicated, but it does require a few basic tools. This guide will walk you through the process of removing your old dishwasher, making new plumbing and electrical connections and securing the unit to the countertop. The key to this project is to follow the directions from your product manual and use caution to prevent accidental injuries or machine damage.
Before you start installing the dishwasher, turn off your water supply valve under the sink. This will make it easier to work in that area without a running water source. Next, place a drop cloth or piece of cardboard on the floor in front of the new dishwasher to protect it from marring. Finally, remove any screws or nails from the cabinet where the dishwasher will go and carefully pull out the old one.
Most of the electrical connections for a dishwasher are made behind an access panel on the front bottom of the unit. You will need to crouch or lie down in order to reach this panel, so it may be best to have a second person help you to make these preliminary connections. Start by removing the access panel and visually identifying the electrical wire connection fittings, as well as the drain and water inlet fittings. These are capped with small plastic sleeve covers, which you will need to remove in order to see what is underneath. Once you have identified the wires, you will need to uncap them and then connect them to their corresponding colored wire nut.
The last connection you will need to make is the drain hose. This is typically a black hose which will need to be attached to the sink tailpiece with a nut. The other end of the hose will be connected to the dishwasher. Make sure that the hose is positioned higher than the sink drain, to avoid backwash from the kitchen sink.
Once all the plumbing and electrical connections are made, you can move on to mounting the dishwasher. This is a very simple process and can be done in under 10 minutes once you’ve got it figured out. Just be sure that the hoses aren’t kinked or obstructed and that all slack is removed.
Once you’ve positioned the dishwasher, use a level to ensure that it is perfectly level on all sides. If necessary, you can adjust the feet of the dishwasher by unscrewing them and moving them as needed to get it centered. Then, screw the dishwasher to the countertop using the screws that are provided. After this is done, you will need to turn the power and water back on and check for any leaks or faulty connections. This is a great time to test the operation of the dishwasher and to adjust the controls. If you find that the appliance doesn’t seem to be working properly, call in a licensed electrician who is certified to work with aluminum wiring.
source https://flowlinkplumbing.wordpress.com/2023/06/23/dishwasher-installation-how-to-install-a-dishwasher/
No comments:
Post a Comment