Adding a dishwasher to your kitchen is a significant investment, so it’s worth spending some time to ensure the installation process goes smoothly. Whether you’re replacing an existing one or installing a new dishwasher where there wasn’t one before, use our step-by-step directions in conjunction with the appliance’s product manual instructions to ensure the proper connections are made.
Before beginning, make sure the dishwasher will fit in its intended space by measuring the width, depth and height of the cabinet opening. You’ll also want to verify that there’s room to route the power cord, drain hose and water supply line through the cabinet to reach their respective ports. If you’re unable to fit the dishwasher, you might need to install a new cabinet door to accommodate it or hire a professional electrician to hardwire your home to add a dedicated circuit and electrical outlet for the appliance.
Shut off the water valve under your sink and the circuit breaker that connects to your dishwasher to make the initial connections. You’ll also need to remove the kick plate or, on newer Maytag dishwashers, the plastic panel at the base of the unit and disconnect the drip tray and drain sensor, if applicable. Tip the dishwasher on its back to make the electrical wiring and plumbing connections easier to access. Remove the cover from the junction box — a square metal box with three exposed wires inside — and feed the ends of your power cord through the round opening in the box. If your dishwasher has a strain relief, slide it over the power cord end and secure it with a ring nut.
Connect the water supply line that came with your dishwasher to that piece on the back of your appliance and to the valve under your sink using the manufacturer’s instructions. You’ll likely need to tighten the connections with a wrench and apply some joint compound, if needed, for a leak-free fit.
Once all the connections are made, replace the junction box cover and screw the kick plate or plastic panel back in place. Attach the drain hose to the drain port on your dishwasher and route it to your sink tail pipe or garbage disposal, following the manufacturer’s instructions for a leak-free connection. Plug in the power cord and run a test cycle to ensure everything works as it should.
With the help of at least one other person, tip the dishwasher upright into its final position and then guide it into place under your counter. Feed the drain hose, water supply line and power cord through the hole in your cabinet to avoid snags. Once the appliance is in place, screw on the metal installation brackets to secure it. If your dishwasher has adjustable legs, use a level to check that the appliance is perfectly level from front to back and side to side.
source https://flowlinkplumbing.wordpress.com/2025/01/11/dishwasher-installation-how-to-install-a-dishwasher-7/
No comments:
Post a Comment