The first step in dishwasher installation is to make sure the unit can fit in its desired spot. Measure the width, depth and height of your cabinet opening and compare it to the measurements of the dishwasher. If your cabinet is too small, or if there is already a dishwasher installed in the space, remove it before continuing with the installation. If the installation area is not under your sink, you may need to drill a hole for the drain hose and power cord to route through the cabinet to your sink tail pipe or garbage disposal unit.
Unpack the dishwasher and remove all packaging materials, including the plastic shipping brace on the back of the unit. Set aside any boards included in the box, which can be used as shims for a tighter fit.
Turn off electricity to the circuit breaker and water supply at the valve under the sink before you begin disconnecting the old dishwasher. Place a shallow bowl or bucket beneath the drain hose to catch any water that spills as you disconnect it.
Locate the water inlet valve on the bottom front of the dishwasher, which will have a round, threaded opening. Most new units use a standard dishwasher inlet, while older models may require an adapter or a different type of supply tube. Check the dishwasher’s owner’s manual for a list of compatible supplies and adapters.
Connect the dishwasher’s power cord and drain hose to the appropriate ports, as specified in the owner’s manual. You will also need to connect the dishwasher’s hot-water supply tube to a shut-off valve on a water line that runs to your house, such as a copper tubing or PVC conduit. The tube is a longer version of the same kind that feeds sink faucets and toilets, so if you’ve worked with those kinds of plumbing fixtures, you shouldn’t have any trouble with this step.
With a helper, tilt the unit on its back and slide it into place. If necessary, position shims on both sides of the cabinet to ensure a snug fit. Secure the shims with screws and metal installation brackets provided by your appliance dealer, if applicable.
If you didn’t install an old dishwasher to replace, you will need to screw in the anchor brackets on the left and right side of the unit. Place a level over the top of the dishwasher to check that it’s flush with the cabinet and adjacent cabinets. If it’s not, adjust the front level legs as needed with pliers to secure the unit in place.
Plug in the dishwasher, and test it by running a cycle as directed in your model’s owner’s manual. Make any final adjustments as needed and reattach the front access panel.
source https://flowlinkplumbing.wordpress.com/2025/04/05/dishwasher-installation-how-to-install-a-dishwasher-9/
No comments:
Post a Comment