Whether you re replacing your old dishwasher, moving it from another location in the kitchen or simply adding an extra one to your kitchen, a dishwasher installation is relatively straightforward and can usually be done with common tools. Before you start, however, it s important to read the manual that came with your new dishwasher for step-by-step instructions specific to your model. Also, it s always a good idea to turn off the power and water supply at the main panel for your kitchen or the area you re working in. This is a safety precaution when working with both water and electricity and should be the first thing you do before beginning any work on your new appliance.
Once your new dishwasher is ready to install, it s best to get someone to help you lift the appliance into place. Carefully tip it on its back and then remove the front access panel to gain access to the electrical and plumbing hookups. Disconnect the old drain hose, if there is one, from either the sink tail pipe or disposal and feed the new one through the opening between the sink and dishwasher area.
You ll also need to route the new dishwasher s power cord and water supply line through the opening between the cabinet and sink. Generally, you will need to feed the supply line through the side of the cabinet and then connect it to a 90-degree elbow fitting that attaches to the dishwasher water valve.
Then, connect the power cord and plug it in. It s a good idea to test it by running a full cycle of dishes, as this will ensure that all connections are properly made and the dishwasher is functioning as it should.
After a few cycles, it s time to turn the electricity and water back on at the main panel for your kitchen or the circuit breaker that connects with the dishwasher. Turn the dishwasher on and use a level to make sure it is perfectly flush with the surrounding cabinets from front to back. If it s not, adjust the front leveling legs until it is.
Once your dishwasher is in place, it s a good idea to use a piece of masking tape around the edges to protect the countertops from any potential scratches. Also, be sure to clean up any excess water that may spill from the dishwasher while it is in operation. With the dishwasher in place, it s a good time to replace the front access panel and replace any screws that were removed in order to access the hookups. Then, enjoy your new dishwasher!
source https://flowlinkplumbing.wordpress.com/2024/11/15/dishwasher-installation-how-to-properly-install-a-dishwasher-2/
No comments:
Post a Comment